HMP 2-Part Solution Builder

MountsClick here to add a mount to the builder
HoldersClick here to add a holder to the builder
AccessoriesClick here to add an optional accessory to the builder
 

ClicOn Angled Mount for Hyundai Tiburon 02-08

With Pre-Drilled AMPS Pattern Holes

SKU:653037

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Attention! Read all instructions before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Press the thin end of the enclosed gap opener into the gap between the dashboard and the surrounding frame to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap above the gap opener. Press Part 1 away from the steering wheel, so the adhesive tape attaches and the angled edge hooks behind/under the control panel. Pull out the gap opener.

  • 2. Press the gap opener into the gap between the control panel and the surrounding frame. Open up the predrilled holes in Part 2 with a screwdriver (Philips).

  • 3. Press the lower corner of the right edge of Part 2 into the gap below the gap opener. Press hard on the upper corner of the right part of Part 2 so it goes into the gap. Pull out the gap opener. Place Part 2 over Part 1 so the holes match. Screw Part 2 onto Part 1 with the enclosed screws. Screw the screws straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Fits: Hyundai Tiburon Year(s):02-08


SKU 653037
Barcode # 7320286530378
Brand ClicOn

Be The First To Review This Product!

Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review

$48.99


Calculate Shipping


More From This Category


SKU: 653037

ClicOn Angled Mount
With Pre-Drilled AMPS Pattern Holes

$48.99

More Info
Not yet rated