Adjustable SmartPhone Holders

Adjustable Smart Phone Holders have been primarily designed to hold a device in a non-wallet type case or cover. These holders will also fit most Smart Phones without a case, please refer to the chart below. The AMPS hole mounting plate on the tilt swivel equips the holder to easily attach to a variety of mounting solutions that include Car Dashboard Mounts, Pedestal Mounts, Bar Mounts, Forklift Mounts or form part of your own solution. Complete with instructions and mounting screws, the holders are easlily self-installed. 

The chart below are for our Non powered  Passive Holders but we also have Powered Holders for Micro USB and USB Type C connector.

Before you purchase make sure you measure the width and thickness (Slot Width)  of your case or device.

 

Item Number Holder Type Holder Width Slot Width
511230 Passive 49-63mm  6-10mm
511231 Passive 49-63mm  9-13mm
511232 Passive 49-63mm 12-16mm
511307 Passive 62-77mm  6-10mm
511308 Passive 62-77mm  9-13mm
511309 Passive 62-77mm 12-16mm
511479 Passive 75-89mm  6-10mm
511483 Passive 75-89mm  9-13mm
511484 Passive 75-89mm 12-16mm

Please note: Industry does not have an official standard mounting hole profile. ClicOn uses the AMPS pattern throughout our range of mounts and holders. The AMPS pattern is a series of four holes aligned in a rectangular profile. Some manufacturers use two of the four holes while maintaining the AMPS pattern spacing dimensions. The four holes are spaced at 30.mm x 38mm (1.181” x 1.496”) and the diagonal measurement at 48.5mm (1.912 inches).