This hardwired charging car phone holder is made for the Apple iPhone Xs Max, and suits phones 80 to 94mm wide and 2 to 10mm thick. Measure the width and thickness with the case on before ordering.
It is hardwired into the vehicle's power, which keeps the 12V socket free and the cabling out of sight. A professional installer is recommended. A tilt swivel turns the screen from portrait to landscape and angles it away from glare.
It is the holder on its own. It screws onto a ClicOn dash mount with the screws provided, so pick the mount made for your vehicle to complete the set-up. When you change phones later, you only need a new holder; the mount stays in the car.
Please note: This Holder connects directly to the vehicle's power system. A professional installer is recommended.
| This Holder Fits | iPhone Xs Max / 11 Pro Max |
| SKU | 727083 |
| Barcode # | 7320287270839 |
| Brand | ClicOn |
| Shipping Weight | 0.3000kg |
Below you will find the installation instructions for the Hard Wired Charging Adjustable Holder (SKU:727083), you can click on the images to open a larger version in a new tab
1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch. Attaching the holder:
1. To adjust the holder for your device: Loosen the screws on the holder's front side, so the holder's sides can be adjusted. Place the device in the holder and press the sides together, so the device is firmly in place. Tighten the screws on the front side of the holder. 2. Loosen the screw in the centre of the holder to remove the tilt swivel attaching plate on the back.
3. Place the attaching plate in the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate, so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, so the thread starts to pull. Pull the holder toward you and hold it slightly tensed; at the same time, tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place but still can be adjusted. NOTE! It is important to slide the device STRAIGHT DOWNWARD into the holder and STRAIGHT UPWARD out of the holder.
4. The holder is in place.
Hardwired charging car phone holder for the Apple iPhone Xs Max. Fits 80-94mm wide, 2-10mm thick. Hardwire install. 360-degree tilt swivel. AMPS pattern holes. Mount sold separately.
