Car Dashboard Mounts

The ClicOn Dashboard mounts are easily self-installed . Full installation instructions come with each mount. No glue or screws are required to attach the mount in position. Once installed the mount provides the platform to attach our range of smartphone, tablet and GPS holders. All our mounts have pre-drilled AMPS pattern holes to assist with mounting the holder into place .

 

 

Step One of a Two-Part Solution

ClicOn Car Dashboard Mounts provide the mounting plate to mount your Smart Phone and GPS devices. The Car Dashboard Mount is the first part of a two-part solution. Once attached to the dashboard, our range of ClicOn Holders can be screwed to the mounting plate completing the solution.

No Holes No Drilling

ClicOn Car Dashboard Mounts provide the platform to mount your communication devices without drilling holes, using glue or suction. No drilling, no vibration, no popping off!

Easy Install

ClicOn Car Dashboard are easily self-installed. Full installation instructions come with each mount. No dismantling of the dashboard or drilling is necessary.

Custom Design

ClicOn Car Dashboard Mounts are specifically designed to fit onto your car dashboard in various positions. Centre Mounts, left of the steering wheel, Angled Mounts, left of the centre console, Right Hand Mounts, right hand side of the streering wheel and Console Mounts, low left and right of the centred console.

Is The ClicOn Mounting System Legal?

Yes! When you use a ClicOn Dashboard Mount and a ClicOn Holder you are complying with the driving rules for mobile phones, in every state and territory of Australia.

Warranty

One Year warranty applies to products purchased directly from HoldMyPhone or an authorised re-seller. During this warranty time if the product is defective in workmanship or materials HoldMyPhone will replace it for a model of equal value. Damages caused by improper care, accident, unauthorised repair or modifications are not covered under this warranty.

Please note: Industry does not have an official standard mounting hole profile. ClicOn uses the AMPS pattern throughout our range of mounts and holders. The AMPS pattern is a series of four holes aligned in a rectangular profile. Some manufacturers use two of the four holes while maintaining the AMPS pattern spacing dimensions. The four holes are spaced at 30.mm x 38mm (1.181” x 1.496”) and the diagonal measurement at 48.5mm (1.912 inches).