This adjustable hardwired charging car phone holder suits phones 62 to 77mm wide and 9 to 13mm thick. Measure the width and thickness with the case on before ordering.
It is hardwired into the vehicle's power, which keeps the 12V socket free and the cabling out of sight. A professional installer is recommended. A tilt swivel turns the screen from portrait to landscape and angles it away from glare.
It is the holder on its own. It screws onto a ClicOn dash mount with the screws provided, so pick the mount made for your vehicle to complete the set-up. When you change phones later, you only need a new holder; the mount stays in the car.
Please note: This Holder connects directly to the vehicle's power. A professional installer is recommended.
| This Holder Fits | Width 62-77 mm, Slot 9 -13 mm |
| SKU | 527841 |
| Barcode # | 7320285278417 |
| Brand | ClicOn |
| Shipping Weight | 0.2000kg |
Below you will find the installation instructions for the Hard Wired Charging Adjustable Holder (SKU:527841), you can click on the images to open a larger version in a new tab
1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
How to mount the holder: 1. To adjust the holder for your device: Loosen the screws on the holder's front side, so the holder's sides can be adjusted. 2. Place the device in the holder and press the sides together, so the device is firmly in place. Adjust the positioning of the charging connector, so it connects properly to the phone. Lock the charging connector into position by screwing the screw into the hole on the side of the charging connector block. Remove the device carefully. Tighten the screws on the front side of the holder.
3. To install the holder: Loosen the screw in the centre of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching container in the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate, so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, so the thread starts to pull. Pull the holder toward you and hold it slightly tensed; at the same time, tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firmly initially, then loosen it a bit, so the holder is firmly in place but still can be adjusted.
4. The holder is in place.
Adjustable hardwired charging car phone holder. Fits 62-77mm wide, 9-13mm thick. Hardwire install. 360-degree tilt swivel. Only for Devices with Type C USB. AMPS pattern holes. Mount sold separately.
