HMP 2-Part Solution Builder
With Pre-Drilled AMPS Pattern Holes
This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided. Please Note: Will cover some controls on the
Please read all of the instructions and look at the pictures before attaching the ClicOn.
1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the padded ledge in the dashboard and the trim below the air vent, to widen the gap. Peel off the adhesive tape cover on the ClicOn. Press the curved edge on the upper part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.
2. Press the thin end of the enclosed gap opener into the gap between the two dashboard sections, to widen the gap. Press forward on the lower part of the ClicOn so the angled edge hooks into the gap next to the gap opener. Pull out the gap opener.
3. and 4. The ClicOn is in place.
|This Mount Fits||
Mazda 3 Year(s):14-18