AUKEY Enduro Dual 65W Fast Car Charger
Dual USB-C, up to 65W
Fit Details
Use with USB A and USB Type C Cables.
$29.90 14% OFF RRP $34.90
The Nissan Patrol 11-24 kit is a complete, vehicle-specific phone mounting solution, custom-designed to fit your dashboard exactly.
This kit includes:
Because the mount is made for your vehicle, it installs with no drilling, no glue and no suction cups, giving a clean install and a firm hold that stays put on rough roads. The two-part design keeps your phone in clear view for safe, hands-free navigation, calls and music, with 25W magnetic wireless charging.
To charge at the full 25W, the holder needs a USB-C power source rated at 25W or more. Most built-in vehicle USB ports supply less than this, so we recommend pairing it with the AUKEY 65W Fast Car Charger (CC-Y23), which plugs into the 12V socket and has a USB-C Power Delivery port for the holder plus a USB-A port for a second device.
Device-use road rules vary by state and territory, so please check the rules that apply where you drive.
| This Mount Fits | Nissan Patrol Year(s):11-24 |
| SKU | 654536-Kit25 |
Below you will find the installation instructions for the Nissan Patrol Angled Mount & MagFusion Dash Pro 25W Kit (SKU:654536-Kit25), you can click on the images to open a larger version in a new tab
1. Open the glove compartment door. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the dashboard and the glove compartment frame, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.
3. Place your fingers behind the right side of the ClicOn and pull so it flexes towards you.Then hook it over the console edge and press/slide the curved edge into the gap between the centre console panel and the padded console edge. Pull out the gap opener and close the glove compartment door.
Vehicle-specific angled mount for the Nissan Patrol 11-24, paired with an Aukey MagFusion Dash Pro magnetic holder for 25W wireless charging. Custom-designed for an exact factory fit with no drilling or glue. Includes a ball joint for easy DIY setup.



