SmartPhone Holders

Professionals on the move, Maps, Mail and Contacts at your finger tips.

Custom design Smartphone Holders are high in quality and low in profile. Complete with a coupling tilt swivel the holders can rotate 360 degrees and adjust 15 degrees in any direction for optimal viewing in a portrait or landscape position. The AMPS hole mounting plate on the tilt swivel equips the holder to easily attach to a variety of mounting solutions that include Car Dashboard Mounts, Pedestal Mounts, Bar Mounts, Suction Mounts or form part of your own solution. Complete with instructions and mounting screws, the holders are easily self-installed.

 


 

Step Two of a Two-Part Solution

ClicOn holders attach to a ClicOn mount to hold your device securely and within easy reach. One part of a two-part solution, or form part of your own kit.

Custom Design

The holders are specifically designed to firmly fit onto your car dashboard without damaging the upholstery, no vibration, no popping off!

Landscape to Portrait

All ClicOn holders come with a built-in tilt swivel that can rotate 360 degrees and adjust the holder 15 degrees in any direction for optimal viewing and avoiding light reflection.

Adjustable Holders

Our adjustable holders are designed to hold the device firmly with or without a skin or cover. The holder can to adjusted to fit the profile of the device in a cover.

Is The ClicOn Mounting System Legal?

Yes! When you use a ClicOn Holder and ClicOn Dashmount you are complying with the driving rules for mobile phones, in every state and territory of Australia.

Easy Install

They are easily self-installed. Full installation instructions come with each Holder. Mounting strews are supplied. No dismantling of the dashboard or drilling is necessary when installing the holder onto a ClicOn Car Dashmount completing the two-part system.

Powered or Non-Powered

The range includes holders from non-powered, or powered by a plug-in car charger, the USB port or hard wired directly into the vehicle’s power system via an in-line 12/24 volts regulator.

Warranty

One Year warranty applies to products purchased directly from HoldMyPhone or an authorised re-seller. During this warranty time if the product is defective in workmanship or materials HoldMyPhone will replace it for a model of equal value. Damages caused by improper care, accident, unauthorised repair or modifications are not covered under this warranty.


Please note: Industry does not have an official standard mounting hole profile. ClicOn uses the AMPS pattern throughout our range of mounts and holders. The AMPS pattern is a series of four holes aligned in a rectangular profile. Some manufacturers use two of the four holes while maintaining the AMPS pattern spacing dimensions. The four holes are spaced at 30.mm x 38mm (1.181” x 1.496”) and the diagonal measurement at 48.5mm (1.912 inches).