HMP 2-Part Solution Builder

MountsClick here to add a mount to the builder
HoldersClick here to add a holder to the builder
AccessoriesClick here to add an optional accessory to the builder
 

ClicOn Charging Holder - Hard Wire Installation

Complete with Tilt Swivel

SKU:727120

A Holder designed to hold your device firmly and securely in position.

Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.

 
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. 3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 4. The holder is in place.

Fits: Huawei P30


SKU 727120
Barcode # 7320287271201
Brand ClicOn

Be The First To Review This Product!

Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review

$119.00


Calculate Shipping


More From This Category


SKU: 711120
Not yet rated
SKU: 721120

ClicOn Charging Cig-Plug Holder USB for Audio
Complete with Tilt Swivel

$119.00

More Info
Not yet rated
SKU: 727120

ClicOn Charging Holder - Hard Wire Installation
Complete with Tilt Swivel

$119.00

More Info
Not yet rated