HMP 2-Part Solution Builder
ClicOn Centre Mount
With Pre-Drilled AMPS Pattern Holes
This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.
Attention! Read all instructions before attaching the ClicOn.
- 1. a) Press the thin end of the two enclosed gap openers into the gap between the dashboard ledge and the air vent frame to widen the gap. (The air vent frame may pop up a little. The distance between the gap openers has to be wider than the width of the ClicOn. b) Peel off the cover of the adhesive tape on the ClicOn. Press the thin angled edge on the upper part of the ClicOn into the gap between the gap openers - don"t press it all the way in so the adhesive tape attaches to the ledge yet.
- 2. a) Remove the right gap opener and slide the ClicOn to the right to desired position. b) Pull the lower part of the ClicOn downwards so it hooks behind the wood grain panel. By doing this you seal the adhesive tape at the top of the ClicOn.
- 3. a) Press up on the lower part of the ClicOn so the angled edge goes all the way in behind the wood grain panel. b) Remove the left gap opener by the upper part of the ClicOn and press down on the air vent panel so it pops back into place.
- 4. The ClicOn is in place
Fits: BMW 728-750 E65 Year(s):02-08
Be The First To Review This Product!
Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.