ClicOn Angled Mount

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Please read all of the instructions and look at the pictures before attaching the ClicOn. This ClicOn is divided into two parts.Part 1: The attaching part (the smallest part)Part 2: The ClicOn faceplate

1. Press the thin end of the enclosed gap openers into the gap between the control panel and the dashboard, to widen the gap. Peel off the cover of the adhesive tape on Part 1. Place the thin edge of Part 1 against the gap between the gap openers.

2. Press the thin edge firmly into the gap and at the same time: bend Part 1 to the left until you see or hear/feel it click into place. Pull out the gap openers.

3. Press a screwdriver (Philips) firmly through the predrilled holes in Part 2 to open them up. Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match and the adhesive tape on Part 2 is on the right side. Do not press the tape to the center console panel frame yet. Screw Part 2 onto Part 1 using the enclosed screws. Right before you tighten the screws press the ClicOn to the left with your thumb for optimal adjustment of the mount. Then press the adhesive tape on the right side of Part 2 to the center panel. Hold the ClicOn in that position and tighten the screws.

4. The ClicOn is in place.