HMP 2-Part Solution Builder
ClicOn Angled Mount
With Pre-Drilled AMPS Pattern Holes
This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.
Attention! Read all instructions before attaching the ClicOn.
This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate
- 1. Press the thin ends of the enclosed gap openers into the gap between the control panel and the dashboard to widen the gap. Place the gap openers about 10 cm apart.
- 2. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap, between the gap openers. Press Part 1 to the left, away from the steering wheel, so the angled edge hooks behing the control panel and the adhesive attaches to the dashboard. Pull out the gap openers.
- 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 over Part 1 so the adhesive tape is on the right and the holes match. Screw Part 2 onto Part 1 by using the enclosed screws. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1.
- 4. The ClicOn is in place.
|This Mount Fits||Mazda 6 Year(s):02-07|
Be The First To Review This Product!
Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.