This adjustable holder is made for larger phones used in a case. It fits devices 75 to 89mm wide and 6 to 10mm thick, which suits many Samsung Galaxy A, Note and S series phones. Measure the width and thickness of your phone with the case on before ordering.
It is a non-charging holder, so there is nothing to wire in. A tilt swivel lets you turn the phone from portrait to landscape and angle the screen to avoid glare.
It is the holder on its own. It screws onto a ClicOn dash mount with the screws provided, so pick the mount made for your vehicle to complete the set-up.
| This Holder Fits | Width 75-89 mm, Slot 6-10mm.Samsung: A / Note / S Series |
| SKU | 511479 |
| Barcode # | 7320285114791 |
| Brand | ClicOn |
| Shipping Weight | 0.1100kg |
Below you will find the installation instructions for the Non Charging Adjustable Holder - Large (SKU:511479), you can click on the images to open a larger version in a new tab
1. To adjust the holder for your device: Loosen the screws on the front side of the holder, so the sides of the holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in place. Tighten the screws on the front side of the holder.
2.To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
3. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.
Adjustable non-charging car phone holder for phones 75-89mm wide and 6-10mm thick, designed to be used with a case. Suits many Samsung Galaxy A, Note and S series phones. 360-degree tilt swivel, AMPS pattern holes. Mount sold separately.
Width 75 - 89 mm, Slot 9 -13 mm
Measure your device and match it to the holder specifications for the right fit.
$69.90
