HMP 2-Part Solution Builder
ClicOn Angled Mount for Ford Endura 15-18
With Pre-Drilled AMPS Pattern Holes
This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.
Please read all of the instructions and look at the pictures before attaching the ClicOn.
1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Insert the thin end of the enclosed gap opener into the gap between the padded center console side and the plastic trim behind, to widen the gap.
2. Align the right side of the ClicOn so that the bottom of the angled right edge is positioned just above the silver trim on the left side of the center console. Take notice of the alignment of the left edge of the ClicOn and adjust the gap opener so it is positioned just below the left edge of the ClicOn. Important: do not insert the right edge into the gap yet! Remove the adhesive tape cover on the ClicOn.
3. Insert the s-shaped left edge of the ClicOn into the gap above the gap opener. Flip the ClicOn rightward so the angled edge goes behind the console panel. Remove the gap opener.
4. Pull the front part of the ClicOn slightly toward you so the angled right edge hooks into the gap between the padded part of the console side wall and the climate control panel. The ClicOn is in place.
Fits: Ford Edge Year(s):15-18
Be The First To Review This Product!
Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.