HMP 2-Part Solution Builder
Charging Holder - Hard Wire Installation
Complete with Tilt Swivel
- The Holder can easily attach to our Pedestal Mounts, Suction Mount, Bar Mounts, and Forklift Mounts or form part of your kit.
FIRM & SECURE FIT
- Customised design to firmly fit your device with original boot.
- Input voltage: DC/10-24V
- Charging voltage DC/4.6-5.3V
- Output current(Typ) 3.0A
- Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection.
AMPS PATTERN MOUNT HOLES
- The AMPS mounting profile is used throughout our range of Mounts and Holders.
Please Note: This Holder connects directly to the vehicle's power system—output 5 Volts. A professional installer is recommended.
- Two-Part Solution
- Firm & Secure Fit
- Hardwire Install
- AMPS mounting profile
|This Holder Fits||