ClicOn Centre Mount

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Attention: For vehcle with navigation unit and wood grain dash.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the wood grain trim and the center console panel, to widen the gap. When you do this the wood grain trim will flex upwards a few millimeters, which is OK. Peel off the cover of adhesive tape on the ClicOn.

2. Press the grooved edge on the lower part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press the gap opener into the gap between the wood grain trim and the dashboard ledge. Press forward on the top part of the gap opener, to widen the gap even more. At the same time: press forward on the upper part of the ClicOn, and then down on the edge of the ClicOn, so the angled edge goes into the gap next to the gap opener. Pull out the gap opener.

4. The ClicOn is in place.