HMP 2-Part Solution Builder

MountsClick here to add a mount to the builder
HoldersClick here to add a holder to the builder
AccessoriesClick here to add an optional accessory to the builder
 

Angled Mount

With Pre-Drilled AMPS Pattern Holes

SKU:655597

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Please read all of the instructions and look at the pictures before attaching the ClicOn.  

1. Press the thin end of the enclosed gap opener into the gap between the air vent and the panel, to widen the gap, placed directly to the right of the air vent control. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape covers on the ClicOn. Press the angled edge on the lower part of the ClicOn into the gap next to the gap opener.  
   
2. Pull out the gap opener. Slide the ClicOn leftwards until it stops, placed directly to the right of the air vent control.  
   
3. Press down on the upper part of the ClicOn so it flexes. Press the upper part of the ClicOn forward so the edge with adhesive tape is placed under the frame surrounding the air vent. Carefully release the pressure so the upper edge is pressed upward toward the frame surrounding the air vent. Press upward on the upper part of the ClicOn so the adhesive tape attaches properly.  
   
4. The ClicOn is in place.  

This Mount Fits

Audi A4 Allroad, Audi A4 Avant, Audi A4 Sedan, Audi A5, Audi S5 Year(s): 20-22

SKU 655597
Barcode # 7320286555975
Brand ClicOn

Be The First To Review This Product!

Help other Neovox Pty Ltd users shop smarter by writing reviews for products you have purchased.

Write a product review

$48.99

Compliment your order with the below



More From This Category


SKU: 655597

Angled Mount
With Pre-Drilled AMPS Pattern Holes

$48.99

More Info
Not yet rated