HMP 2-Part Solution Builder
With Pre-Drilled AMPS Pattern Holes
This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.
Please read all of the instructions and look at the pictures before attaching the ClicOn.
This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate
- 1. Press the thin ends of the enclosed gap openers into the gap between the frame surrounding the control panel and the dashboard, to widen the gap. Place them about 10 cm apart. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap between the gap openers.
- 2. Press Part 1 leftwards, so the angled edge hooks behind the frame surrounding the control panel and the adhesive tape attaches to the dashboard. Pull out the gap openers.
- 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the adhesive tape is on the right side and the holes fit. Screw Part 2 onto Part 1 with the enclosed screws. Screw straight into Part 1, in the same angle as Part 1.
4. The ClicOn is in place.
|This Mount Fits||Subaru Impreza Year(s):05-07|